Requirements for fineness of spiral chutes

The requirement for fineness of spiral chutes is that the selection of chutes belongs to the process of inclined surface flow selection. Mortar is given to a partially inclined inclined chute or inclined surface. Under the push of water, the mineral particle group is loose and layered, and the upper layer of light minerals quickly flows out of the groove. The lower layer of heavy minerals are retained inside the groove or discharged slowly from the lower part. After receiving each, selected ore and tailings can be obtained. What is the maximum angle of the spiral chute? The fiberglass spiral chute is an equipment for mining and beneficiation, making it ideal for sand mining and beneficiation on beaches, river beds, beaches, and streams. The equipment has the characteristics of suitable structure, simple installation, small land occupation, simple operation, stable beneficiation, clear separation, strong processing capacity, high efficiency, high concentration, high recovery rate, and reliable operation. It has advantages such as light weight, moisture prevention, rust prevention, corrosion resistance, and strong adaptability to fluctuations in ore feed volume, concentration, particle size, and grade. 2、 The technical principle is the same: the mortar is slowly fed to the rotating groove surface through a feeding groove installed on the spiral groove head for sorting. The tail end of the spiral groove is equipped with a valve block type product cutting groove, which divides the selected equipment into three types according to grade along the radial direction. By adjusting the orientation of the valve block to change the acquisition width of each product, the equipment gathering hopper allows the selected multi head ore flow to be differentiated and aggregated for export. The cross section of the spiral concentrator has different slopes, which is particularly suitable for the separation of small particle ore materials. The requirements for fineness of the spiral chute are three key characteristics: 1. Stable, easy to operate, and a large density range. 2. The material processing capacity is large, the enrichment ratio is high, and the probability of recovery is high. 3. Small space occupation, low water consumption, simple structure, and no need for power. Requirements for fineness of spiral chutes 4. Easy installation, easy operation, low investment, and fast efficiency. The requirements for fineness of spiral chutes are . Spiral chutes do not require water. Fourthly, the structural composition of the fiberglass chute consists of six parts: a feeding distributor, a feeding chute, a rotating chute, an equipment intercepting chute, a product gathering hopper, and a groove support (including a cross or triangular frame). The spiral groove formed by the connection of spiral plates is a key component. The rotating plate is made of fiberglass (fiberglass reinforced coal gangue) and is bolted together. The selected surface of the rotating groove has a pre designed durable wear-resistant layer. It has the advantages of being lightweight, sturdy, durable, and not easily damaged consumer goods. The spiral groove is equipped with a multi tube feeding homogenizer to divide ore evenly, making it easy to operate. The concentrator is not limited to being placed on the cross (or tripod) of the support table. The evenly divided mineral mortar is slowly fed onto the spiral groove surface through the feeding chute at the head of the rotating groove for sorting. The tail of the rotating groove is installed in a valve type new product selection groove, and the selected new products are divided into three types (or four types) of new equipment along the radial direction according to grade. Change the width of each new product by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that allows the intercepted multi-directional mineral flow to converge and lead out. The cross section of the spiral chute and the different slopes of the curves are very suitable for sorting fine particle materials. 5、 In the field of application, the requirement for fineness of spiral chutes is that fiberglass spiral chutes are suitable for processing 0.6-0.03 millimeters and vein ores as well as sand ores, but they are unfavorable for sorting when the mud content is high. Nowadays, it has been widely used for processing iron ore, tungsten, tin ore, tantalum niobium ore, coastal and riverbed ore, or gold ore. Requirements for fineness of spiral chutes Requirements for fineness of spiral chutes