Coal selection spiral chute manufacturer

A gravity beneficiation equipment that utilizes the inertial centrifugal force generated by the slurry in the spiral rotary motion to separate light and heavy mineral materials. 2、 The application method is to erect the spiral concentrator, align it with the vertical line, use an iron frame or wood to stabilize it in a suitable position, and use a sand pump to deliver the ore sand to the two feeding ports above the spiral. The sand is mixed with supplementary water to adjust the density of the ore mortar. The ore mortar naturally swirls from high to low, and there is an inertial centrifugal force in the rotating slope flow rate, which varies in density, specific gravity, particle size, and state of the ore sand, The effect of gravity and centrifugal force is achieved through swirling flow, separating the sand from the ore. The selected ore flows into the concentrate hopper and is piped out, while the tailings enter the tailings hopper and are piped to the sand tank. They are then discharged by a sand pump, completing the entire beneficiation process. Coal Preparation Spiral Chute Manufacturer III. Special spiral chute has attracted special attention in many gravity beneficiation machines due to its low power consumption, simple structure, small floor area, simple operation, stable beneficiation, clear beneficiation, no moving parts, convenient Computerized maintenance management system, large processing capacity per area and other characteristics. The machine has a relatively wide and stable groove surface, and the mineral mortar has a large area of laminar flow, which is more suitable for processing medium and fine (-4mm) Granularity ores. Fiberglass spiral chutes with diameters of 400, 600, 900, and 1200MM have been manufactured domestically, Ф The production of 1200 millimeters of four heads is approximately 4-6 tons per hour. Coal selection spiral chute manufacturer 4. The structural composition of the fiberglass chute is composed of six parts: a feeding homogenizer, a feeding groove, a rotating groove, an equipment acquisition groove, a product gathering hopper, or a groove bracket (including a cross or triangular frame). The spiral groove formed by connecting spiral pieces is the main component. The rotating plate is made of fiberglass (fiberglass reinforced coal gangue), which is connected together through screws. The selected surface of the rotating groove has a pre designed durable anti wear layer. It also has the advantages of lightweight, sturdy, and long-lasting consumer goods. The head of the spiral groove is equipped with a multi tube feeding homogenizer for screening ore, which is simple to operate. The mineral separator does not need to be restricted to placing on a cross (or tripod) on a support table. The evenly distributed slurry is slowly fed onto the spiral groove surface through a feeding chute installed at the head end of the rotating groove, and sorting is carried out. The bottom of the rotating groove is installed in a valve block type new product cutting groove, and the selected new equipment is divided into three (or four) types of new products according to grade along the radial direction. Change the width of each new product by adjusting the position of the valve block. The new equipment gathering bucket is a concentric annular tube that allows the selected variable ore flows to be densely exported. The transverse surface of the fiberglass spiral chute and the slope of the curve change, which is particularly suitable for the separation of small particle mineral materials. 5、 The application scope of this machine is to separate iron, ferrotitanium, chromite ore, pyrite ore, zircon ore, Rutile ore, monazite ore, phosphorus, tungsten ore sand, cassiterite, tantalum niobium, niobium ore or other non-ferrous metal ore, rare metal or non-metallic ore body with gravity difference from 0.3-0.02mm fine material. Coal selection spiral chute manufacturer Coal selection spiral chute manufacturer