How to install the spiral chute

How to install the spiral chute I. Introduction The gravity separation spiral chute is a combination of the characteristics of spiral chute, spiral chute, shaking table, and centrifuges for mineral processing. After the relevant scientific research organized by the Ministry of Metallurgical Industry, and the appraisal carried out by the design, universities, mines and other departments, it is recognized that this kind of mechanism has excellent performance and progress in sorting goals. At the same time, it has won the scientific and technological research achievement award from the Ministry of Metallurgical Industry. It has been used in a large number of non-ferrous and Ferrous mines. This machine is suitable for separating iron ore, ferrotitanium ore, chromite ore, pyrite ore, zircon, Rutile, monazite, phosphate ore, wolframite, placer tin, tantalum niobium ore, tantalum niobium ore or other non-ferrous metal ores, rare mineral metals or non-metallic minerals with gravity difference from 0.3-0.02 mm fine materials. 2、 The mineral mortar with the same technical principle is slowly fed to the surface of the spiral groove through the feeding groove installed at the end of the rotating groove head, and then selected for operation. The bottom of the rotating groove is equipped with a valve block type equipment selection groove, which divides the sorted products into three categories according to grade along the radial direction. By adjusting the position of the valve block to change the acquisition width of each device, the product gathering hopper allows the intercepted variable mineral flow to be converged and exported separately. The transverse plane of the fiberglass spiral chute is particularly suitable for the separation of fine ore materials when the slope of the curve changes. How to Install the Spiral Chute at . Highlights and Features: 1. Ultra high efficiency, high recycling rate, and accurate mineral screening; 2. No power required; 3. Lightweight, rust resistant, durable, wear resistant, and corrosion-resistant; 4. Low cost and long service life; 5. Strong adaptability to fluctuations in ore feed volume, concentration, particle size, and grade; The friction force formed by the surface of 6 diamond sand makes the beneficiation effect superior to other plastic surfaces. How to Install a Spiral Chute @ @ 000 4. Structural Composition: The Spiral Chute consists of six parts: a feeding homogenizer, a feeding trough, a rotating trough, a product acquisition trough, an equipment gathering hopper, and a support bracket for this trough (including a cross or tripod). The spiral groove connected by the rotating disc is a key component. The spiral plate is made of fiberglass (fiber reinforced coal gangue), and a wear-resistant layer is pre made on the sorting surface of the rotating groove through bolts. She has the advantages of lightweight, strong, and durable consumer goods. Above the spiral groove, a multi tube feeding homogenizer is installed to evenly distribute the ore, and the operation is not complicated. The screening machine is not limited to being placed on the cross (or tripod) of the support table. The evenly distributed slurry is slowly fed onto the spiral groove surface through the feeding chute installed at the head of the rotating groove, and sorting is carried out. The tail end of the rotating groove is equipped with a valve block type new equipment to intercept the groove, allowing the sorted new products to be divided into three categories (or four categories) according to grade along the radial direction. Change the selection width of each new equipment by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that gathers and exports various obtained mineral flows. The lateral plane of the spiral concentrator and the slope change of the curve are extremely suitable for the selection of fine-grained materials. 5、 Scope of application: FRP spiral chute is used to separate fine grained iron ore, ilmenite ore, chromite ore, pyrite ore, sand tin, tantalum niobium ore, placer gold ore, coal mine, monazite, Rutile, zircon ore, rare earth ore or other metal and non-metallic mineral materials with sufficient Density contrast. How to Install the Spiral Chute How to Install the Spiral Chute