Where is the spiral chute

Where is there a spiral chute? Gravity beneficiation is widely used in metal and non-metallic ore beneficiation due to its low environmental pollution and cost. The spiral concentrator is one of the gravity separation equipment, with a structural characteristic that the cross-section presents a cubic parabolic state, suitable for processing finer particle sizes of -0.2MM. In the sorting process, there is no need to add flushing water, and fine, medium, and tailings are selected in sections at the tail of the tank. 2、 The working principle of the spiral mineral separator is that the mineral separator is freely placed on the cross (or tripod) of the support table. The same mortar is slowly fed onto the spiral groove surface through a feeding chute installed on the rotating groove head for sorting. A valve type equipment is installed at the tail to obtain a slot, allowing the sorted products to be divided into three (or four) categories according to grade along the radial direction. Change the selection width of each device by adjusting the position of the valve block. The product gathering bucket is a concentric circular tube that distinguishes and converges the intercepted multi-directional mineral flow. The transverse surface of the fiberglass chute and the slope change of the curve are very suitable for selecting fine-grained materials. Where are the three characteristics of the spiral chute? 1. Stable sorting process and easy control. 2. Wide range of allowable changes in ore concentration. 3. Ultra high enrichment ratio and high recycling rate. 4. Small land area and water consumption. 5. Simple structure, no power required. 6. More production. 7. Simplified installation and easy operation. 8. Small investment and quick effect. Where are the spiral chutes It consists of six parts: a feeding chute, a spiral groove, an equipment cutting groove, a product gathering hopper or groove bracket (including a cross or triangular frame), and so on. The main component is the rotating groove connected by the rotating disc. The spiral plate is made of fiberglass (fiber reinforced coal gangue) and is bolted together. The sorting surface of the spiral groove has a pre made wear-resistant layer. She has the advantages of lightweight, sturdy, and durable consumables. A multi tube feeding homogenizer is installed above the rotating groove to evenly sort minerals, making control simple and convenient. The mineral screening device is not limited to being placed on a cross (or tripod) on a supporting table. Uniform mineral mortar is slowly fed to the rotating groove surface through the feeding groove installed at the end of the spiral groove head, and selection is carried out. The tail end of the spiral groove is equipped with a valve block type new equipment to obtain the groove. The sorted new products are divided into three (or four) types of new products along the radial direction according to grade. Change the selection width of each new product by adjusting the orientation of the valve block. The new equipment gathering bucket is a concentric circular tube that allows the intercepted and variable mineral flows to be densely drawn out. The transverse section of the fiberglass chute and the slope change of the curve are extremely suitable for the selection of fine particle materials. 5、 The spiral concentrator is suitable for separating fine grained iron ore, Ilmenite, Chromite, pyrite, cassiterite, tantalum niobium ore, placer gold ore, coal, monazite ore, Rutile ore, zircon sand, rare earth ore and other metal and non-metallic mineral materials with sufficient density ratio difference. Where is the spiral chute? @ @ 000 Where is the spiral chute