Can the 2000 spiral chute select coal

Can the 2000 type spiral chute be used for coal separation? 1. Introduction: The gravity separation spiral chute combines the characteristics of gravity beneficiation spiral chutes, spiral concentrators, shakers, and centrifugal gold concentrators. After being evaluated and approved by relevant scientific research, design, universities, or beneficiation enterprises organized by the Ministry of Metallurgical Industry, it is considered to have excellent mechanical performance, advanced sorting indicators, and has been awarded the Science and Technology Research Achievement Award by the Ministry of Metallurgy. It is now in the field of non-ferrous metals Ferrous is widely used. This machine is suitable for separating iron ore, Ilmenite, Chromite, pyrite, zircon, Rutile, monazite, phosphate rock, tungsten sand, sand tin, tantalum niobium ore, niobium and other non-ferrous metals, rare metals and non colored metal minerals with different specific gravity from fine materials with a Granularity of 0.3-0.02 mm. 2、 The working principle is the same: mineral mortar is slowly fed onto the rotating groove surface through the feeding groove installed at the end of the spiral groove head, and selection is carried out. The tail end of the spiral groove is equipped with a valve type product selection groove, which divides the sorting equipment into three types according to grade along the radial direction. By adjusting the orientation of the valve block to change the cutting width of each product, the equipment gathering bucket allows the obtained variable mineral flow to be collected and exported. The cross section and slope of the curve of the spiral concentrator are very suitable for the separation of fine particle materials. Can the 2000 type spiral chute be used for coal separation? 3. Characteristics: 1. Stable and easily controlled sorting steps. 2. Allowing for a wide range of feed concentration. 3. High enrichment ratio and recovery rate. 4. It occupies a small area and consumes less water. 5. Its structure is simple and does not require power. 6. Its production capacity is large. 7. Its installation is simplified and easy to operate. 8. It has low investment and quick results. Can the 2000 type spiral chute be used for coal separation According to the particle size of the ore being processed, the chute can be divided into three categories: (1) Coarse grained chute, with a maximum particle size of 2-3 millimeters or more for ore feeding, and a maximum of 100-200mm. (2) The ore sand chute is used to handle 2-3 millimeter sized ore materials. (3) Slurry chute, feeding Granularity is less than 0.074MM. 5、 The application scope of fiberglass chute is used for processing 0.6-0.03 millimeters and this vein or placer ore, but it is unfavorable for sorting when the mud content is high. Currently, it has been widely used for processing iron ore, tungsten, tin ore, tantalum niobium ore, coastal and riverine minerals, and gold ore. Can the 2000 type spiral chute clean coal? Can the 2000 type spiral chute clean coal