Spiral chute model

Spiral chute model 1 illustrates that gravity beneficiation is widely used in the beneficiation of metal or non-ferrous metals due to its low pollution and cost. The spiral concentrator is one of the gravity separation machines, characterized by a cubic parabola shaped cross-section, suitable for processing finer particle sizes of -0.2 millimeters. In the sorting process, no flushing water is required, and the tailings are obtained by dividing them into sections at the tail end of the tank. 2、 The mortar with the same working principle is slowly fed to the surface of the spiral groove through the feeding groove installed at the end of the rotating groove head, and sorting is carried out. The tail end of the rotating groove is equipped with a valve block type product cutting groove, allowing the selected equipment to be divided into three types according to grade along the radial direction. By adjusting the position of the valve block to change the selection width of each product, the equipment gathering hopper will collect and export the obtained multi head ore flow. The transverse plane of the spiral chute and the different slopes of the curves are particularly suitable for the separation of small particles of mineral materials. Spiral Chute Model III. Highlight Features 1. Stable, easy to control, and with a large concentration range. 2. Strong production and processing capacity of mineral materials, high enrichment ratio, and high recovery probability. 3. The area is not occupied much, with low water consumption, simple structure, and no need for power. 4. Installation is simple and easy to operate, with low investment and fast returns. Spiral chute model 4. Construction of a fiberglass spiral chute consists of six parts: a feeding homogenizer, a feeding chute, a spiral groove, a product acquisition groove, an equipment gathering hopper, and a groove bracket (including a cross or triangular frame). The rotating groove formed by connecting rotating discs is the main component. The spiral plate is made of fiberglass (fiberglass reinforced coal gangue) and is connected together through screws. The sorting surface of the spiral groove has a pre designed durable wear-resistant layer. She has the advantages of being lightweight, sturdy, and durable in using consumables. There is a multi tube feeding homogenizer above the rotating groove to screen minerals evenly, which is not cumbersome to operate. The screening machine does not need to be restricted from being placed on the cross (or tripod) on the support table. The uniform slurry is slowly fed to the surface of the spiral groove through the feeding groove on the rotating groove head, and sorting is carried out. The tail of the rotating groove is installed in a valve type new equipment selection groove, allowing the sorted new products to be divided into three (or four) types of new products according to grade along the radial direction. Change the width of each new device by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that separates and merges the intercepted multi-directional mineral flows. The cross section of the spiral chute and the slope change of the curve are very applicable to the selection of fine materials. 5、 This machine is suitable for separating fine materials with Granularity of 0.3-0.02mm to get iron ore, ferrotitanium ore, chromite ore, pyrite ore, zircon sand, Rutile ore, monazite ore, phosphorus, tungsten sand, placer tin ore, tantalum niobium, niobium ore or other non-ferrous metal ores, rare metals and non-ferrous metal minerals with different density and specific gravity. Spiral Chute Model Spiral Chute Model