Installation standards for spiral chutes

Spiral chute installation standard 1: Introduction: The chute beneficiation includes the slope flow beneficiation process. Mineral mortar is fed to some inclined inclined grooves or slopes. With the assistance of flowing water, the mineral particle group is not tightly fastened and layered. The upper part of the light mineral material is quickly discharged to the outside of the groove, while the lower part of the heavy mineral material stagnates in the inner groove or flows out at a slow speed from the lower part. After being obtained, the selected ore and tailings can be obtained. Spiral chutes are mining and beneficiation machinery, especially ideal for sand mining along coasts, rivers, sandbanks, and streams. The product is also characterized by suitable structure, easy installation, small footprint, easy operation, stable beneficiation, clear beneficiation, large processing capacity, high efficiency, ultra-high enrichment ratio, high recovery rate, and stable operation. It has the advantages of small weight, moisture prevention, rust prevention, strong corrosion resistance, and strong applicability to the fluctuation of feed volume, density, Granularity, and grade. 2、 The mineral mortar with the same working principle is slowly fed onto the rotating groove surface through the feeding chute installed at the head of the spiral groove for sorting. The bottom of the spiral groove is equipped with a valve block type product acquisition groove, and the selected equipment is divided into three types according to grade along the radial direction. By adjusting the position of the valve block to change the cutting width of each product, the equipment gathering hopper allows the selected multi head ore flow to be collected and exported separately. The cross section of the spiral concentrator, with a change in the slope of the curve, is extremely suitable for the selection of fine-grained materials. Standard 3 for Installation of Spiral Chutes: Advantages: 1. Stable, easy to operate, and with a large density range. 2. High material processing yield, high enrichment ratio, and high recycling rate. 3. Small footprint, low water consumption, simple structure, and no need for power. 4. Simple installation, simple operation, low investment, and fast returns. The installation standard for spiral chutes is IV. The structural composition of the fiberglass chute is composed of 6 parts, including a feeding homogenizer, a feeding chute, a rotating chute, a product intercepting chute, an equipment gathering hopper or a groove bracket (including a cross or triangular frame), etc. The spiral groove connected by the spiral plate is the main component. The rotating plate is made of fiberglass (fiber reinforced coal gangue), which is connected together through screws. The selected surface of the rotating groove has a predetermined wear-resistant layer. It also has the advantages of lightweight, sturdy, and durable consumer goods. Above the spiral groove, there is a multi tube feeding homogenizer for ore dressing and averaging, with simple control. The mineral screening device is freely placed on a cross (or tripod) on a support table. The evenly distributed mortar is slowly fed to the rotating groove surface by installing it on the feeding groove at the end of the spiral groove head, and sorting is carried out. The tail end of the spiral groove is installed in a valve block type new product acquisition groove, and the selected new products are divided into three categories (or four categories) of new equipment along the radial direction according to grade. Change the selection width of each new product by adjusting the orientation of the valve block. The new product gathering bucket is a concentric circular tube that allows the intercepted variable mineral flows to be gathered and exported separately. The cross section and slope of the curve of the spiral concentrator are particularly suitable for the separation of fine ore materials. 5、 Scope of application Spiral concentrator is suitable for separating fine grained iron ore, Ilmenite, Chromite, pyrite, placer tin, tantalum niobium ore, placer gold, coal, monazite ore, Rutile ore, zircon sand, rare earth ore or other metal and non-metallic ore with sufficient gravity difference. Installation standard for spiral chutes Installation standard for spiral chutes