How much are spiral chutes and spiral concentrators

How much are spiral chutes and spiral concentrators? Introduction. The sorting of minerals by the chute belongs to the step of inclined flow sorting. Mineral mortar is provided on a partially inclined chute or inclined surface. With the assistance of water, the mineral particle group is not tightened and layered. The lighter mineral material on the upper part is quickly discharged to the outside of the chute, while the heavier mineral material on the lower part stays in the inner groove or flows out at a slow speed from the lower part. After being obtained separately, concentrate and tailings are obtained. The fiberglass spiral chute is an equipment for mining and beneficiation, making it ideal for mining sand mines in coastal areas, riverbanks, sandbanks, and streams. The product also has the characteristics of reasonable structure, simple installation, less land occupation, simple operability, stable beneficiation, clear screening of ore, large processing output, high efficiency, high beneficiation concentration ratio, high recovery rate, and reliable operation. It has the advantages of light weight, moisture prevention, rust prevention, corrosion prevention, and strong applicability to feed volume, density, Granularity, and grade fluctuation. 2、 The working principle is the same: mineral mortar is slowly fed onto the rotating groove surface through the feeding groove installed at the end of the spiral groove head, and selection is carried out. The tail end of the spiral groove is equipped with a valve type product selection groove, which divides the sorting equipment into three types according to grade along the radial direction. By adjusting the orientation of the valve block to change the cutting width of each product, the equipment gathering bucket allows the obtained variable mineral flow to be collected and exported. The cross section and slope of the curve of the spiral concentrator are very suitable for the separation of fine particle materials. How much is the cost of the spiral chute and spiral concentrator? 3. Advantages and characteristics: 1. High efficiency, high recovery rate, and correct ore sorting; 2. No power required; 3. Lightweight, rust resistant, durable, wear resistant, and corrosion-resistant; 4. Low operating costs and long service life. 5. Strong adaptability to fluctuations in ore feed volume, concentration, particle size, and grade; The friction force caused by the surface of 6 diamond sand makes the beneficiation effect better than other plastic surfaces. How much are spiral chutes and spiral concentrators. The fiberglass chute is composed of six parts: a feeding homogenizer, a feeding trough, a rotating trough, an equipment acquisition trough, a product gathering hopper, or a trough bracket (including a cross or tripod). The spiral groove formed by connecting spiral pieces is the main component. The rotating plate is made of fiberglass (fiberglass reinforced coal gangue), which is connected together through screws. The selected surface of the rotating groove has a pre designed durable anti wear layer. It also has the advantages of lightweight, sturdy, and long-lasting consumer goods. The head of the spiral groove is equipped with a multi tube feeding homogenizer for screening ore, which is simple to operate. The mineral separator does not need to be restricted to placing on a cross (or tripod) on a support table. The evenly distributed slurry is slowly fed onto the spiral groove surface through a feeding chute installed at the head end of the rotating groove, and sorting is carried out. The bottom of the rotating groove is installed in a valve block type new product cutting groove, and the selected new equipment is divided into three (or four) types of new products according to grade along the radial direction. Change the width of each new product by adjusting the position of the valve block. The new equipment gathering bucket is a concentric annular tube that allows the selected variable ore flows to be densely exported. The transverse surface of the fiberglass spiral chute and the slope of the curve change, which is particularly suitable for the separation of small particle mineral materials. How much is the spiral chute and spiral concentrator? 5. Scope of use. The spiral chute is applicable to the separation of fine grained iron ore, ferrotitanium ore, chromite ore, pyrite, sand tin, tantalum niobium ore, placer gold, coal, monazite, Rutile, zircon ore, rare earth ore and other metal and non-metallic mineral materials with sufficient proportion difference. How much is the spiral chute and spiral concentrator? How much is the spiral chute and spiral concentrator