Spiral chute debugging

Spiral Chute Debugging I. Product Overview. A gravity beneficiation equipment that utilizes the continuous centrifugal force generated by mortar in rotary spiral motion to achieve lightweight and heavy mineral separation. 2、 The method of use is to set up the fiberglass chute, calibrate the vertical line, use an iron frame or wood to fix it in the appropriate position, and use a slurry pump to send the sand ore to the two feeding ports on the spiral head to supplement water and adjust the density of the mineral sand slurry. The mineral sand slurry naturally rotates from top to bottom, and an inertial centrifugal force occurs in the flow speed of the rotating inclined plane, which varies in density, specific gravity, particle size, and morphology of the sand ore, Through the action of gravity or centrifugal force through swirling flow, the sand and ore are separated. The selected ore flows into the concentrate hopper and is piped out, while the tailings flow into the tailings hopper and are piped to the sand pit. Then, they are discharged by a sand pump, completing the entire beneficiation process. 3 Spiral Chute Debugging III. Highlights and Features 1. High efficiency, high recovery probability, and accurate beneficiation; 2. No power required; 3. Lightweight, anti rust, durable, anti wear, and strong corrosion resistance; 4. Low operating costs and long application life. Strong applicability to fluctuations in ore feed volume, concentration, particle size, and grade; The frictional force formed on the surface of 6 diamond sand makes the beneficiation effect better than other plastic surfaces. Spiral chute debugging IV. Structural composition. Spiral chute debugging: The spiral chute consists of six parts: a feeding homogenizer, a feeding chute, a rotating chute, a product intercepting chute, an equipment gathering hopper, and a support bracket (including a cross or triangular frame). The spiral groove connected by the rotating plate is a key accessory. The spiral plate is made of fiberglass (fiberglass reinforced with coal gangue) and connected together by bolts. The sorting surface of the rotating groove has a pre made wear-resistant layer. It has the advantages of lightweight, sturdy, and long-lasting consumer goods that are not easily damaged. The spiral groove is equipped with a multi tube feeding homogenizer for ore dressing, which is easy to operate. There is no need to restrict the stacking of mineral sievers on the cross (or tripod) of the support table. The evenly distributed mineral mortar is slowly fed to the surface of the spiral groove through the feeding groove at the beginning of the rotating groove, and then selected for operation. The bottom of the rotating groove is equipped with a valve block type new product selection groove, which allows the sorting equipment to be divided into three categories (or four types) of new products according to grade along the radial direction. Change the acquisition width of each new product by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that collects and exports the intercepted variable mineral flows. The cross section and slope of the curve of the fiberglass chute are very suitable for the selection of fine particle materials. 5、 Scope of use. The application range of fiberglass spiral chutes is to handle 0.6-0.03 millimeters or vein ores and minerals, but high mud content is unfavorable for sorting. At present, it has been widely used for processing iron ore, tungsten, tin ore sand, tantalum niobium, coastal and river placers, and placer gold mines. Spiral chute debugging Spiral chute debugging