How much is it for a re selected spiral chute

How much is the cost of a gravity separation spiral chute? One unit. Introduction: Gravity beneficiation is widely used in the beneficiation of metal and non-metallic minerals due to its low environmental pollution and low cost. The spiral chute is one of the gravity sorting machines, with a structural characteristic of a cubic parabolic cross-section. It is used to process finer particle sizes of -0.2mm, and does not require flushing water during the sorting step. Fine, medium, and tailings are segmented at the bottom of the chute. 2、 The spiral chute shall be set up by means of method, the vertical line shall be calibrated, the iron frame or wood shall be used to stabilize at the appropriate position, the sand ore shall be transported to the two ore feeding ports on the spiral roof by the slurry pump, the water shall be added, the concentration of mineral slurry shall be adjusted, the slurry shall naturally rotate from high to low, and a single coherent centrifugal force shall be generated in the rotating slope flow speed, and the difference in density, specific gravity, Granularity and morphology of the sand ore shall be obtained, Through the gravity and centrifugal force of the swirling flow, the sand and ore are separated. The selected ore is discharged into the concentrate hopper and connected out through pipelines. The tailings flow into the tailings hopper and are transported to the sand pit through pipelines. Then, they are discharged by a mortar pump, completing the entire beneficiation process. How much is a gravity concentration spiral chute? 3. Features This machine is suitable for separating iron ore, ferrotitanium ore, chromite ore, pyrite ore, zircon sand, Rutile ore, monazite ore, phosphorus, tungsten sand, sand tin, tantalum niobium, tantalum niobium and other non-ferrous metal ore bodies with different density and specific gravity of small materials with a Granularity of 0.3-0.02mm. This machine has advantages such as stable sorting process, easy control, wide range of ore concentration tolerance, high enrichment, high recovery probability, small land occupation, low water consumption, simple structure, no need for power, large production capacity, simple installation, simple operation, small investment, and quick effectiveness. How much is the cost of a re selected spiral chute? A set of 4. The structure of a fiberglass spiral chute consists of six parts: a feeding homogenizer, a feeding chute, a spiral groove, a product cutting groove, an equipment gathering hopper or a groove support (including a cross or triangular frame). The rotating groove connected by the rotating disc is a key component. The spiral plate is made of fiberglass (fiber reinforced coal gangue) and connected together by bolts. The sorting surface of the spiral groove has a pre made durable and wear-resistant layer. He also has the advantages of lightweight, strong, and durable consumables. The head of the rotating groove is equipped with a multi tube feeding homogenizer to sort minerals evenly, which is easy to control. The ore separator is not restricted from being placed on the cross (or tripod) of the support table. The evenly distributed mortar is slowly fed onto the surface of the rotating groove through a feeding groove installed at the end of the spiral groove head, and selected for operation. The tail end of the spiral groove is installed in a valve block type new product selection groove, allowing the sorting equipment to be divided into three types (or four types) of new products along the radial direction according to grade. Change the acquisition width of each new product by adjusting the position of the valve block. The new equipment gathering bucket is a concentric circular tube that converges and leads out the intercepted multiple ore flows. The lateral plane of the spiral concentrator and the change in slope of the curve are particularly suitable for the selection of small particle ore materials. 5、 The application scope of this machine is to separate iron, ferrotitanium, chromite ore, pyrite ore, zircon ore, Rutile ore, monazite ore, phosphorus, tungsten ore sand, cassiterite, tantalum niobium, niobium ore or other non-ferrous metal ore, rare metal or non-metallic ore body with gravity difference from 0.3-0.02mm fine material. How much is the cost of a re selected spiral chute per unit? @ @ 000 @ @ How much is the cost of a re selected spiral chute per unit