6-piece assembled spiral chute

6-piece assembled spiral chute 1. Describing the chute beneficiation process including inclined surface flow sorting steps. The slurry is fed into a inclined chute or slope, and under the push of water, the mineral particle group is loose and layered. The lighter minerals in the upper layer quickly flow out of the groove, while the minerals in the lower layer with a higher specific gravity stay inside the groove or discharge from the bottom at a low speed. After being extracted, the concentrate and tailings are obtained. The spiral concentrator is an equipment for mining and beneficiation, especially ideal for sand mining in coastal areas, riverbanks, beaches, and streams. The equipment has the characteristics of appropriate structure, simple installation, small land occupation, simple operation, stable beneficiation, clear screening of ore, large output, high efficiency, high enrichment ratio, high recycling rate, and reliable operation. There are also advantages such as small weight, moisture resistance, rust prevention, corrosion resistance, and strong adaptability to fluctuations in ore feed volume or concentration, particle size, and grade. 2、 The spiral chute shall be set up by means of method, the vertical line shall be calibrated, the iron frame or wood shall be used to stabilize at the appropriate position, the sand ore shall be transported to the two ore feeding ports on the spiral roof by the slurry pump, the water shall be added, the concentration of mineral slurry shall be adjusted, the slurry shall naturally rotate from high to low, and a single coherent centrifugal force shall be generated in the rotating slope flow speed, and the difference in density, specific gravity, Granularity and morphology of the sand ore shall be obtained, Through the gravity and centrifugal force of the swirling flow, the sand and ore are separated. The selected ore is discharged into the concentrate hopper and connected out through pipelines. The tailings flow into the tailings hopper and are transported to the sand pit through pipelines. Then, they are discharged by a mortar pump, completing the entire beneficiation process. 6 pieces of assembled spiral chute 3. Features 1. Stable sorting process and easy control 2. Wide range of allowable ore concentration 3. High enrichment ratio and recovery probability 4. Small land occupation and low water consumption 5. Simple structure, no power required 6. Strong processing capacity 7. Easy installation and operation 8. Small investment and quick effect 6 pieces of assembled spiral chute 4. The structure is composed of a fiberglass spiral chute with a feeding homogenizer The feeding chute, spiral groove, product acquisition groove, equipment gathering hopper, and groove bracket (including cross or triangular frame) are composed of six parts. The rotating groove formed by connecting rotating discs is the main component. The spiral plate is made of fiberglass (fiberglass reinforced coal gangue) and is connected together through screws. The sorting surface of the spiral groove has a pre designed durable wear-resistant layer. She has the advantages of being lightweight, sturdy, and durable in using consumables. There is a multi tube feeding homogenizer above the rotating groove to screen minerals evenly, which is not cumbersome to operate. The screening machine does not need to be restricted from being placed on the cross (or tripod) on the support table. The uniform slurry is slowly fed to the surface of the spiral groove through the feeding groove on the rotating groove head, and sorting is carried out. The tail of the rotating groove is installed in a valve type new equipment selection groove, allowing the sorted new products to be divided into three (or four) types of new products according to grade along the radial direction. Change the width of each new device by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that separates and merges the intercepted multi-directional mineral flows. The cross section of the spiral chute and the slope change of the curve are very applicable to the selection of fine materials. 5、 Scope of use: FRP spiral chute is suitable for separating fine grain iron, ferrotitanium, ferrochrome, pyrite, cassiterite, tantalum niobium, gold, coal, monazite, Rutile, zircon ore, rare earth ore or other metal and non nonferrous metal minerals with sufficient specific gravity difference. 6-piece assembled spiral chute 6-piece assembled spiral chute