Spiral chute for gold mining

Spiral Chute for Gold Mining 1. Product Introduction: A gravity beneficiation equipment that utilizes the inertial centrifugal force that occurs during the spiral rotation movement of ore slurry to separate light and heavy mineral materials. 2、 The spiral chute shall be set up with skills, the vertical line shall be calibrated, the iron frame or wood shall be used to fix the suitable position, the sand pump shall be used to transport the ore sand to the two ore inlets above the spiral, the increased water shall be added, and the density of the ore slurry shall be adjusted. The ore slurry shall naturally rotate from high to low, and a coherent centrifugal force shall be generated in the flow speed of the rotating inclined plane to obtain the difference in gravity, Granularity and shape of the sand ore, By utilizing the functions of gravity and centrifugal force generated by swirling flow, the ore and sand are separated. The concentrate flows into the beneficiation hopper and is piped out. The tailings are discharged into the tailings hopper and moved to the sand pit through a pipeline. Then, they are discharged by a slurry pump, completing the entire beneficiation process. Spiral chute for gold mining 3. Features This equipment is suitable for separating iron ore, Ilmenite, Chromite, pyrite, zircon sand, Rutile, monazite, phosphate ore, tungsten ore, tin, tantalum niobium ore, tantalum niobium ore or other non-ferrous metal, rare ore metal and nonferrous metal mineral bodies with specific gravity difference from fine materials with Granularity of 0.3-0.02mm. This equipment has the advantages of stable sorting steps, easy operation, wide range of allowable changes in feed density, high enrichment ratio, high recycling rate, small area occupation, low water consumption, simple structure, no power, strong processing ability, simple installation, easy operation, small investment, and quick effectiveness. The spiral chute for gold mining is composed of six parts: a feeding homogenizer, a feeding groove, a rotating groove, a product acquisition groove, an equipment gathering hopper, and a groove bracket (including a cross or triangular frame). The spiral groove formed by connecting the spiral pieces is a key component. The rotating plate is made of fiberglass (fiberglass reinforced coal gangue) and connected together by screws. The selection surface of the rotating groove has a pre made wear-resistant layer. She has the advantages of lightweight, sturdy, and durable consumer goods that are not easily damaged. The head of the spiral groove is equipped with a multi tube feeding homogenizer to sort minerals evenly, which is not cumbersome to operate. The mineral sorting device is freely placed on the cross (or tripod) of the support table. The evenly divided mortar is slowly fed onto the surface of the spiral groove through the feeding chute at the head end of the rotating groove for sorting. The tail of the rotating groove is installed in a valve block type new product selection groove, allowing the selection of new equipment to be divided into three (or four) types of new products radially according to grade. Change the cutting width of each new device by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that distinguishes and converges the obtained multi head ore flows. The horizontal plane of the spiral concentrator is particularly suitable for the separation of small particle ore materials when the slope of the curve changes. 5、 The fiberglass spiral chute is suitable for processing 0.6-0.03mm and vein ore as well as sand ore, but it is unfavorable for sorting when the mud content is high. Nowadays, it has been widely used for processing iron ore, tungsten, tin ore, tantalum niobium ore, coastal and riverbed ore, or gold ore. Spiral chute for gold mining Spiral chute for gold mining