Cutting method of 90 degree rectangular spiral chute

The cutting method of a 90 degree rectangular spiral chute is described as follows: 1. The beneficiation chute belongs to the inclined flow sorting process. Mortar is provided on a inclined chute or slope. Under the driving force of flowing water, the mineral particle group is not tight and layered. The upper layer of light minerals is quickly discharged from the groove, while the lower layer of minerals with a significant proportion are retained in the groove or discharged from the bottom at low speed. After being distinguished and connected, fine ore dressing or tailings can be obtained. Glass fiber reinforced plastic chutes are machinery for mining and beneficiation, especially ideal for mineral mining and beneficiation on beaches, riverbanks, sandbanks, and river beds. The equipment has the characteristics of suitable structure, simple installation, small footprint, simple operation, stable beneficiation, clear beneficiation, large production capacity, high efficiency, high concentration ratio, high recovery rate, and reliable operation. And it has the advantages of light weight, moisture resistance, rust prevention, corrosion resistance, strong applicability to fluctuations in ore feed volume, concentration, particle size, and grade. 2、 The principle of operation is that the slurry is slowly fed to the rotating groove surface through the feeding chute at the end of the spiral groove head, and sorting is carried out. The tail of the spiral groove is equipped with a valve type product acquisition groove, allowing other equipment to be classified into three categories according to grade along the radial direction. By adjusting the orientation of the valve block to change the selection width of each product, the equipment gathering bucket will densely extract the intercepted multi-directional mineral flow. The cross section of the spiral concentrator and the slope change of the curve are extremely suitable for the selection of fine materials. The cutting method of the rectangular spiral chute with a degree of 90. Advantages and characteristics: 1. High efficiency, high recovery rate, and correct mineral sorting; 2. No power required; 3. Small weight, anti rust, durable, anti wear, and strong corrosion resistance; 4. Low operating cost and long service life; 5. Strong adaptability to fluctuation of feed volume, density, Granularity and grade; The frictional force formed on the surface of 6 diamond sand makes the beneficiation efficiency better than other plastic surfaces. The cutting method of a 90 degree rectangular spiral chute is . 4. The structural composition of a fiberglass spiral chute is composed of a feeding homogenizer, a cross (tripod), a feeding chute, a spiral groove, a receiving groove, a gathering bucket, and a groove support. 5、 The range of spiral chutes used is suitable for separating fine grained iron, ferrotitanium, ferrochrome, pyrite, tin ore, tantalum niobium, gold ore, coal, monazite ore, Rutile ore, zircon, rare earth ore or other metal and non-metallic mineral materials with sufficient specific gravity difference. Cutting Method for 90 Degree Rectangular Spiral Chutes Cutting Method for 90 Degree Rectangular Spiral Chutes