Spiral Chute Official Website

The official website of spiral chutes introduces the process of chute beneficiation, including inclined flow separation. The slurry is fed to a inclined groove or inclined surface, and with the assistance of flowing water, the mineral particle group is not tightly fastened and layered. The lighter minerals in the upper layer are quickly discharged to the outside of the groove, while the heavy ore materials in the lower part stagnate in the inner groove or flow out at a slow speed from the lower part. After being collected separately, the concentrate and tailings can be obtained. Glass fiber reinforced plastic chutes are machinery for mining and beneficiation, especially ideal for sand mining and beneficiation in bays, riverbanks, sandbanks, and streams. The product has the characteristics of reasonable structure, simple installation, small footprint, simple operation, stable beneficiation, clear separation of ore, large processing output, high efficiency, high beneficiation enrichment ratio, high recovery rate, and reliable operation. It has the advantages of light weight, moisture prevention, rust prevention, corrosion prevention, and strong applicability to fluctuations in feed volume, density, Granularity, and grade., Spiral chute official website 2. The slurry with the same technical principle is slowly fed onto the surface of the spiral chute through the feeding groove installed at the head of the rotating groove for selection. The tail end of the rotating groove is equipped with a valve block type equipment to select the groove, allowing the sorted products to be divided into three categories according to grade along the radial direction. By adjusting the position of the valve block to obtain the width of each device, the product gathering hopper will differentiate and densely extract the intercepted multi-directional mineral flow. The cross-section of the spiral chute and the slope change of the curve are particularly suitable for the separation of fine particle materials. Spiral Chute Official Website 3. Highlights and Characteristics 1. Stable, easy to operate, and wide density range. 2. The material processing capacity is large, the enrichment ratio is high, and the probability of recovery is high. Coal selection spiral chute manufacturer, spiral chute official website 3. Small space occupation, low water consumption, simple structure, and no need for power. 4. Easy installation, easy operation, low investment, and fast efficiency. Spiral chute official website IV. Structural composition. The spiral concentrator is composed of six parts, including a feeding homogenizer, a feeding chute, a rotating groove, a product cutting groove, an equipment gathering hopper, and a groove bracket (including a cross or triangular frame). The spiral groove formed by connecting the spiral pieces is the main component. The rotating plate is made of fiberglass reinforced coal gangue and connected together through screws. The sorting surface of the rotating groove has a pre made durable wear-resistant layer. It also has the advantages of lightweight, sturdy, durable, and durable consumer goods. The head of the spiral groove is equipped with a multi tube ore feeder to evenly separate minerals, and the control is not complicated. The concentrator is not limited to being placed on a cross (or tripod) on a support table. The evenly distributed mortar is slowly fed onto the surface of the spiral groove through the feeding chute installed at the beginning of the rotating groove, and sorting is carried out. The tail end of the rotating groove is equipped with a valve type new product acquisition groove. The selected new products are divided into three (or four) types of new equipment along the radial direction according to grade. Change the selection width of each new product by adjusting the orientation of the valve block. The new product gathering bucket is a concentric circular tube that allows the obtained multi-directional mineral flow to be collected and exported separately. The cross section and slope of the spiral chute are extremely suitable for the selection of fine particle materials. 5、 Application: This machine is suitable for separating fine materials with Granularity of 0.3-0.02mm to obtain iron ore, ferrotitanium ore, chromite ore, pyrite ore, zircon sand, Rutile ore, monazite ore, phosphorus, tungsten sand, tin placer, tantalum niobium, niobium ore or other non-ferrous metal ores, rare metals and non-ferrous metal minerals with different density and specific gravity. Spiral Chute Official Website Spiral Chute Official Website