Maximum feed of spiral chute

The maximum feed of spiral chute 1. Introduction: The chute beneficiation belongs to the slope flow beneficiation process. Mortar is fed to some inclined grooves or slopes, and under the push of water flow, the mineral particle group becomes loose and layered. The upper layer of light minerals quickly flows out of the groove, while the lower layer of minerals with high specific gravity remain inside the groove or are discharged from the bottom at a low speed. After separation and collection, selected minerals and tailings can be obtained. The spiral concentrator is a machine for mining and beneficiation, making it ideal for mining ore in bays, river beds, sand banks, and streams. The equipment has the characteristics of correct structure, simple installation, small land occupation, simple operation, stable beneficiation, clear separation, large processing volume, high efficiency, high beneficiation enrichment ratio, high recycling rate, and reliable operation. It has the advantages of light weight, moisture resistance, rust prevention, corrosion resistance, and strong adaptability to fluctuations in feed volume, concentration, particle size, and grade. 2、 Production principle: The spiral mineral separator is not limited to placing on the cross (or tripod) of the support table. The uniform slurry is slowly fed to the rotating groove surface through the feeding groove installed at the head of the spiral groove for sorting. A valve type product selection slot is installed at the tail, allowing the selection equipment to be divided into three (or four) categories according to grade along the radial direction. Adjust the orientation of the valve block to obtain the width of each device. The product gathering bucket is a concentric circular tube that distinguishes and densely draws out the intercepted multi-directional mineral flow. The transverse surface of the fiberglass spiral chute and the slope change of the curve are particularly suitable for the selection of fine particle materials. Maximum feeding of spiral chute 3. Characteristics 1. Stable separation process and simple control 2. Large allowable range of ore feeding concentration 3. High enrichment ratio and high recovery probability 4. Small area occupied, low water consumption 5. Simple structure, no power required 6. Large processing capacity 7. Simple installation and easy operation 8. Small investment, quick results. Maximum feeding of spiral chute 4 According to the Granularity of the processed ore materials, the chutes can be divided into three categories: (1) coarse spiral chutes. The maximum particle size of the feed is more than 2-3mm, and the maximum can reach 100-200mm. (2) Mineral sand chute, processing 2-3 millimeter sized ore. (3) Slime spiral chute, feeding Granularity<0.074mm. 5、 The use of a range spiral concentrator is suitable for processing 0.6-0.03mm or vein ore and minerals, but it is unfavorable for separation when the mud content is high. Nowadays, it is widely used for processing iron ore, tungsten, tin, tantalum niobium ore, bay or riverbank ore sand, and gold ore. Spiral chute maximum feed Spiral chute maximum feed